NASHVILLE, Tenn. — An Alaska Airlines jet taking off in Nashville on Thursday braked to a rapid stop on the runway to avoid a possible collision with a Southwest Airlines plane, and federal agencies are investigating the incident.
The Federal Aviation Administration said the Alaska pilots aborted their takeoff because the Southwest plane was cleared to cross the end of the same runway. A Southwest Airlines spokesperson confirmed the plane had left from Hobby Airport earlier in the day.
An Alaska Airlines spokesperson said the pilots recognized “a potential traffic conflict on the runway” and “immediately applied the brakes to prevent the incident from escalating.”
No injuries were reported, but tires on the Boeing 737 Max went flat from the extreme heat buildup during the stop, according to the Seattle-based airline.
The FAA and the National Transportation Safety Board said they were investigating the incident, which happened at about 9:15 a.m. at Nashville International Airport.
Southwest said it was in contact with the FAA and the NTSB and will participate in the investigation.
Alaska Airlines said the flight to Seattle carried 176 passengers and six crew members. The plane was being inspected, and another plane was dispatched to take passengers to Seattle by Thursday night, the airline said.
A series of close calls, or “runway incursions,” in the last two years raised concern about the safety of U.S. air travel. NTSB Chair Jennifer Homendy said last November the incidents, while “incredibly rare” compared to the number of flights, show that the aviation system is under stress.
Some of the incidents have been blamed on pilots not following instructions from air traffic controllers. However, the scariest of the close calls – a FedEx jet landing in Austin, Texas, flew over the top of a Southwest jet that was taking off on a foggy early morning in February 2023 – was blamed on an air traffic controller’s mistakes.
